Investigation of deformations of a lithium polymer cell using the Digital Image Correlation Method (DICM)
DOI:
https://doi.org/10.31181/rme20008022022sKeywords:
GOM ATOS, GOM ARAMIS, Battery deformation, DIC, DICM.Abstract
This research aims to investigate the adaptability of a measurement system or a process in determining the parameters of batteries. Methods are suggested for different applications, and properties gained by these measurements are specified. Deformations of lithium polymer batteries measured by various methodologies are also analyzed in detail. Changes in the geometry of worn-out batteries and the localization of the changes can be better understood by applying the results. The GOM ATOS and the GOM ARAMIS systems were applied to characterize lithium polymer batteries. Discontinuous tests were performed and the battery was discharged to 0 V and then fully charged for both methods. The advantages and disadvantages and the applicability of the two measurement systems were analyzed in this topic.
References
Bajusz, L., Kátai-Urbán, G., Pintér, I., & Megyesi Z. (2019). Viewpoint correct content projection on arbitrary surface. Gradus, 6(1), 33–42. (in Hungarian)
Burguete, R. L., Lucas, M., Patterson, E. A., & Quinn, S. (2011). Speckle pattern characterisation for high resolution digital image correlation. Applied Mechanics and Materials, 70, 261–266. https://doi.org/10.4028/www.scientific.net/AMM.70.261.
Dong, Y. L., & Pan, B. (2017). A Review of Speckle Pattern Fabrication and Assessment for Digital Image Correlation. Experimental Mechanics, 57(8). https://doi.org/10.1007/s11340-017-0283-1.
Dunn, J. B., Gaines, L., Kelly, J. C., James, C., & Gallagher, K. G. (2015). The significance of Li-ion batteries in electric vehicle life-cycle energy and emissions and recycling’s role in its reduction. Energy and Environmental Science, 8(1), 158–168. https://doi.org/10.1039/c4ee03029j.
Ehrlich, G. M. (2002). Linden’s Handbook of Batteries. (4th ed.). New York: McGraw Hill Professional, 2002.
Fotouhi, A., Auger, D. J., Propp, K., Longo, S., & Wild, M. (2016). A review on electric vehicle battery modelling: From Lithium-ion toward Lithium-Sulphur. Renewable and Sustainable Energy Reviews, 56, 1008–1021. https://doi.org/10.1016/j.rser.2015.12.009.
Freddi, A., Olmi, G., & Cristofolini, L. (2015). Experimental Stress Analysis for Materials and Structures: Stress Analysis Models for Developing Design Methodologies. Cham: Springer, Springer Series in Solid and Structural Mechanics, 2015. https://doi.org/10.1007/978-3-319-06086-6.
Goda, I., Lhostis, G., & Guerlain, P. (2019). In-situ non-contact 3D optical deformation measurement of large capacity composite tank based on close-range photogrammetry. Optics and Lasers in Engineering, 119, 37–55. https://doi.org/10.1016/j.optlaseng.2019.02.006.
GOM (2021a). GOM Metrology to Go.
https://www.gom.com/en/explore-gom/gom-metrology-to-go (Accessed: 31 December 2021).
GOM (2021b) ATOS Compact Scan.
https://www.gom.com/en/products/3d-scanning/atos-compact-scan (Accessed: 31 December 2021).
GOM GmbH (2011). GOM ATOS III Triple Scan User Manual.
https://www.manualslib.com/products/Gom-Atos-Iii-Triple-Scan-10970231.html (Accessed: 31 December 2021).
GOM GmbH (2021). Moules et Outillages de Bourgogne: 3D Scanning of Molds Used for Investment Casting.
https://www.gom.com/fileadmin/user_upload/industries/GOM_France_Investment_Casting_Application_Note_EN.pdf (Accessed: 31 December 2021).
Gualtieri, S. (2012) Novel technique for DIC speckle pattern optimization and generation. PhD thesis, Polotecnico di Milano.
How, D. N. T., Hannan, M. A., Hossain Lipu, M. S., & Ker, P. J. (2019). State of Charge Estimation for Lithium-Ion Batteries Using Model-Based and Data-Driven Methods: A Review. IEEE Access, 7, 136116–136136. https://doi.org/10.1109/ACCESS.2019.2942213.
Jones, E. M. C., Silberstein, M. N., White, S. R., & Sottos, N. R. (2014). In Situ Measurements of Strains in Composite Battery Electrodes during Electrochemical Cycling. Experimental Mechanics, 54(6), 971–985. https://doi.org/10.1007/s11340-014-9873-3.
Kocsis Szürke, S., Dineva, A., Szalai, S., & Lakatos, I. (2022). Determination of Critical Deformation Regions of a Lithium Polymer Battery by DIC Measurement and WOWA Filter. Acta Polytechnica Hungarica, 19(2), 113–134.
Kocsis Szurke, S., & Lakatos, I. (2018). The lithium polymer battery swelling test with high-precision displacement sensors. 20th International Symposium on Electrical Apparatus and Technologies, SIELA 2018 - Proceedings, 7–10. https://doi.org/10.1109/SIELA.2018.8447119.
Komsiyska, L., Buchberger, T., Diehl, S., Ehrensberger, M., Hanzl, C., Hartmann, C., Hölzle, M., Kleiner, J., Lewerenz, M., Liebhart, B., Schmid, M., Schneider, D., Speer, S., Stöttner, J., Terbrack, C., Hinterberger, M., & Endisch, C. (2021). Critical Review of Intelligent Battery Systems: Challenges, Implementation, and Potential for Electric Vehicles. Energies 2021, 14(18), 5989; https://doi.org/10.3390/en14185989.
Leung, P. K., Moreno, C., Masters, I., Hazra, S., Conde, B., Mohamed, M. R., Dashwood, R. J., & Bhagat, R. (2014). Real-time displacement and strain mappings of lithium-ion batteries using three-dimensional digital image correlation. Journal of Power Sources, 271, 82–86. https://doi.org/10.1016/j.jpowsour.2014.07.184.
Li, J. (2011). A lithium battery pole thickness measurement system based on laser displacement sensor. 2011 International Conference on Electric Information and Control Engineering, ICEICE 2011 - Proceedings, 1016–1020. https://doi.org/10.1109/ICEICE.2011.5777625.
Li, W., Liu, G., Zhu, L., Li, X., Zhang, Y., & Shan, S. (2016). Efficient detection and recognition algorithm of reference points in photogrammetry. Optics, Photonics and Digital Technologies for Imaging Applications IV, SPIE Photonics Europe, 2016, Brussels, Belgium, Proceedings 9896, 989612. https://doi.org/10.1117/12.2225416.
Luhmann, T., Robson, S., Kyle, S., & Boehm, J. (2019). Close-Range Photogrammetry and 3D Imaging, Berlin, Boston: De Gruyter, 2019. https://doi.org/10.1515/9783110607253.
NASA (2014) Short range full-field non-contact structured blue light 3D scanning and photogrammetry for rapid and accurate inspection analysis.
https://www.nasa.gov/sites/default/files/files/S_DeRemer-Short_Range_Full-field_Structured_Blue_Light_3D_Scan_Photo-Gpdf.pdf (Accessed: 31 December 2021).
Popp, H., Koller, M., Jahn, M., & Bergmann, A. (2020). Mechanical methods for state determination of Lithium-Ion secondary batteries: A review. Journal of Energy Storage, 32, 101859. https://doi.org/10.1016/j.est.2020.101859.
Reu, P. (2012). Introduction to digital image correlation: Best practices and applications. Experimental Techniques, 36(1), 3–4. https://doi.org/10.1111/j.1747-1567.2011.00798.x.
Reu, P. (2014) Speckles and their relationship to the digital camera. Experimental Techniques, 38(4), 1–2 https://doi.org/10.1111/ext.12105.
Reu, P. (2015). Virtual Strain Gage Size Study. Experimental Techniques, 39(5), 1–3. https://doi.org/10.1111/ext.12172.
Rezvanizaniani, S. M., Liu, Z., Chen, Y., & Lee, J. (2014). Review and recent advances in battery health monitoring and prognostics technologies for electric vehicle ( EV ) safety and mobility. Journal of Power Sources, 256, 110–124. https://doi.org/10.1016/j.jpowsour.2014.01.085.
Rieger, B., Erhard, S. V., Rumpf, K., & Jossen, A. (2016). A New Method to Model the Thickness Change of a Commercial Pouch Cell during Discharge. Journal of The Electrochemical Society, 163(8), A1566–A1575. https://doi.org/10.1149/2.0441608jes.
Sauerteig, D., Ivanov, S., Reinshagen, H., & Bund, A. (2017). Reversible and irreversible dilation of lithium-ion battery electrodes investigated by in-situ dilatometry. Journal of Power Sources, 342, 939–946. https://doi.org/10.1016/j.jpowsour.2016.12.121.
Slattery, M., Dunn, J., & Kendall, A. (2021). Transportation of electric vehicle lithium-ion batteries at end-of-life : A literature review. Resources, Conservation & Recycling, 174, 105755. https://doi.org/10.1016/j.resconrec.2021.105755.
Speckle Pattern Fundamentals Correlated Solutions (2018) Correlated Solutions: Application Note AN-1701.
https://www.correlatedsolutions.com/ support/index.php?/Knowledgebase/Article/View/80/1/speckle-pattern-fundamentals (Accessed: 31 December 2021).
Szalai, S. (2021). Investigation of formability of aluminum vehicle body sheets. PhD thesis, Széchenyi István University (in Hungarian).
Szalai, S., & Dogossy, G. (2021). Speckle pattern optimization for DIC technologies. Acta Technica Jaurinensis, 14(3), 228–243. https://doi.org/10.14513/actatechjaur.00573.
Tao, R., Zhu, J., Zhang, Y., Song, W. L., Chen, H., & Fang, D. (2020). Quantifying the 2D anisotropic displacement and strain fields in graphite-based electrode via in situ scanning electron microscopy and digital image correlation. Extreme Mechanics Letters, 35, 100635. https://doi.org/10.1016/j.eml.2020.100635.
Vagovský, J., Buranský, I., & Görög, A. (2015). Evaluation of measuring capability of the optical 3D scanner. Procedia Engineering, 100, 1198–1206. https://doi.org/10.1016/j.proeng.2015.01.484.
Wang, Y., Tian, J., Sun, Z., Wang, L., Xu, R., Li, M., & Chen, Z. (2020). A comprehensive review of battery modeling and state estimation approaches for advanced battery management systems. Renewable and Sustainable Energy Reviews, 131, 110015. https://doi.org/10.1016/j.rser.2020.110015.
Yufit, V., Shearing, P., Hamilton, R. W., Lee, P. D., Wu, M., & Brandon, N. P. (2011). Investigation of lithium-ion polymer battery cell failure using X-ray computed tomography. Electrochemistry Communications, 13(6), 608–610. https://doi.org/10.1016/j.elecom.2011.03.022.
Zhang, N., Tang, H., Zhang, L., & Trifonova, A. (2015). Asymmetric Electrode for Suppressing Cell Swelling in Commercial Lithium Ion Batteries. Journal of The Electrochemical Society, 162(10), A2152–A2156. https://doi.org/10.1149/2.0881510jes.
Zheng, L., Zhang, L., Zhu, J., Wang, G., & Jiang, J. (2016). Co-estimation of state-of-charge, capacity and resistance for lithium-ion batteries based on a high-fidelity electrochemical model. Applied Energy, 180, 424–434. https://doi.org/10.1016/j.apenergy.2016.08.016.
Zhu, J., Wierzbicki, T., & Li, W. (2018). A review of safety-focused mechanical modeling of commercial lithium-ion batteries. Journal of Power Sources, 378, 153–168. https://doi.org/10.1016/j.jpowsour.2017.12.034.
